Klipper Installation for Anycubic Vyper
  • Introduction
    • Before You Begin
    • What You Need
  • Setting Up Your Raspberry Pi
    • Installing Mainsail
    • Configuring WiFi Settings
    • Finding Your IP Address
    • Raspberry Pi Software Configuration Tool
      • Changing the Default Password
      • Changing the Hostname
      • Changing the Localisation Options
  • Klipper Firmware
    • Klipper Firmware Creation
    • Klipper Firmware Flashing
  • Printer Configuration File
  • Configuration Checks
    • Verify Temperatures
    • Verify M112
    • Verify Heaters
    • Verify Stepper Motor Enable Pin
    • Verify Endstops
    • Verify Stepper Motors
    • Verify Extruder Motor
    • Verify Filament Runout Sensor
    • Verify LED Light
  • Initial Tuning
    • Calibrate Probe Z Offset
    • Calibrate Bed Mesh
    • Calibrate PID Settings
  • Macros and Slicer
    • Macros
      • Simplify3D Settings
    • Making Prints
      • Determining Thermal Expansion
  • Advanced Tuning
    • Resonance Compensation
    • Pressure Advance
Powered by GitBook
On this page

Setting Up Your Raspberry Pi

I use a Raspbery Pi 3 B+ for all of my installations, I already had one of these devices for each of my printers previously running OctoPrint/OctoPi. This guide will only cover installing Klipper on a Raspberry Pi, but you don't need to have this particular model.

The official Klipper Installation documentation provides additional information on what devices can be used.

PreviousWhat You NeedNextInstalling Mainsail

Last updated 3 years ago