Configuration Checks

Performing these 'Configuration Checks' will verify if your Anycubic Vyper 3D printer is properly communicating with Klipper.

Here is the list of checks that you will perform:

• Verify Temperatures

• Verify M112

• Verify Heaters

• Verify Stepper Motor Enable Pin

• Verify Endstops

• Verify Stepper Motors

• Verify Extruder Motor

• Verify Filament Runout Sensor

• Verify LED Light

The remaining sections of this guide will assume you have already logged into your MainsailOS web interface;

• Open a web browser of your choice;

• Enter the IP Address of your Raspbery Pi, the same IP address you found in the Determining the Pi IP Address section;

  • If everything has been configured properly to this point, you should be presented with the Dashboard;

Dashboard