Klipper Installation for Anycubic Vyper
  • Introduction
    • Before You Begin
    • What You Need
  • Setting Up Your Raspberry Pi
    • Installing Mainsail
    • Configuring WiFi Settings
    • Finding Your IP Address
    • Raspberry Pi Software Configuration Tool
      • Changing the Default Password
      • Changing the Hostname
      • Changing the Localisation Options
  • Klipper Firmware
    • Klipper Firmware Creation
    • Klipper Firmware Flashing
  • Printer Configuration File
  • Configuration Checks
    • Verify Temperatures
    • Verify M112
    • Verify Heaters
    • Verify Stepper Motor Enable Pin
    • Verify Endstops
    • Verify Stepper Motors
    • Verify Extruder Motor
    • Verify Filament Runout Sensor
    • Verify LED Light
  • Initial Tuning
    • Calibrate Probe Z Offset
    • Calibrate Bed Mesh
    • Calibrate PID Settings
  • Macros and Slicer
    • Macros
      • Simplify3D Settings
    • Making Prints
      • Determining Thermal Expansion
  • Advanced Tuning
    • Resonance Compensation
    • Pressure Advance
Powered by GitBook
On this page
  1. Configuration Checks

Verify Filament Runout Sensor

PreviousVerify Extruder MotorNextVerify LED Light

Last updated 3 years ago

This section explains how to verify if the Filament Runout Sensor is working as expected.

  • With a piece of filament loaded into the Filament Runout Sensor;

    • The Runout feature located in the Miscellaneous section of the Dashboard should report detected;

  • Without a piece of filament loaded into the Filament Runout Sensor;

    • The Runout feature located in the Miscellaneous section of the Dashboard should report empty;

Filament Loaded
Runout Feature - detected
Filament Unloaded
Runout Feature - Empty