Klipper Installation for Anycubic Vyper
  • Introduction
    • Before You Begin
    • What You Need
  • Setting Up Your Raspberry Pi
    • Installing Mainsail
    • Configuring WiFi Settings
    • Finding Your IP Address
    • Raspberry Pi Software Configuration Tool
      • Changing the Default Password
      • Changing the Hostname
      • Changing the Localisation Options
  • Klipper Firmware
    • Klipper Firmware Creation
    • Klipper Firmware Flashing
  • Printer Configuration File
  • Configuration Checks
    • Verify Temperatures
    • Verify M112
    • Verify Heaters
    • Verify Stepper Motor Enable Pin
    • Verify Endstops
    • Verify Stepper Motors
    • Verify Extruder Motor
    • Verify Filament Runout Sensor
    • Verify LED Light
  • Initial Tuning
    • Calibrate Probe Z Offset
    • Calibrate Bed Mesh
    • Calibrate PID Settings
  • Macros and Slicer
    • Macros
      • Simplify3D Settings
    • Making Prints
      • Determining Thermal Expansion
  • Advanced Tuning
    • Resonance Compensation
    • Pressure Advance
Powered by GitBook
On this page
  1. Introduction

Before You Begin

PreviousIntroductionNextWhat You Need

Last updated 3 years ago

These instructions are provided specifically for the Anycubic Vyper 3D printer. Please note that installing Klipper on your Anycubic Vyper requires some experience with 3D printers and hardware. This is not a trivial task for beginners, and it is possible to break your printer if you don't understand/follow the directions carefully. If you don’t feel comfortable doing this, I would recommend keeping the stock firmware.

Read this and the official carefully, and only install Klipper on your Anycubic Vyper if you fully understand all of the steps required. I've installed Klipper on all 3 of my Anycubic Vyper printers, but I will not be responsible for any damage you may cause to your printer by following this guide.

This guide will use the MainsailOS installation method only, I've found this the easiest method to use, there are other guides out there if you are looking for a different installation method.

The and files shared in this guide, were made for the stock Anycubic Vyper. It’s also worth noting that the stock touchscreen on your Anycubic Vyper will not work once you install Klipper. You will need to use the WebUI for controlling the printer, or you could purchase a compatible KlipperScreen touchscreen (recommended).

Klipper Installation Guide
firmware
printer.cfg