Klipper Installation for Anycubic Vyper
  • Introduction
    • Before You Begin
    • What You Need
  • Setting Up Your Raspberry Pi
    • Installing Mainsail
    • Configuring WiFi Settings
    • Finding Your IP Address
    • Raspberry Pi Software Configuration Tool
      • Changing the Default Password
      • Changing the Hostname
      • Changing the Localisation Options
  • Klipper Firmware
    • Klipper Firmware Creation
    • Klipper Firmware Flashing
  • Printer Configuration File
  • Configuration Checks
    • Verify Temperatures
    • Verify M112
    • Verify Heaters
    • Verify Stepper Motor Enable Pin
    • Verify Endstops
    • Verify Stepper Motors
    • Verify Extruder Motor
    • Verify Filament Runout Sensor
    • Verify LED Light
  • Initial Tuning
    • Calibrate Probe Z Offset
    • Calibrate Bed Mesh
    • Calibrate PID Settings
  • Macros and Slicer
    • Macros
      • Simplify3D Settings
    • Making Prints
      • Determining Thermal Expansion
  • Advanced Tuning
    • Resonance Compensation
    • Pressure Advance
Powered by GitBook
On this page

Initial Tuning

PreviousVerify LED LightNextCalibrate Probe Z Offset

Last updated 3 years ago

Performing these 'Initial Tuning' steps will prepare your printer for your first test prints. More advanced tuning will follow, but performing the following tuning steps will allow you to start printing some files.

Here is a list of the the initial tuning steps that you will perform:

Calibrate Probe Z Offset
Calibrate Bed Mesh
Calibrate PID Settings