Printer Configuration File

This section explains the process of uploading the printer.cfg file to Klipper that was created to work with a stock Anycubic Vyper printer. This file has been tested on three of my Anycubic Vyper printers and is the starting point to ensure the printer is communicating and functioning properly. As you continue through the tuning sections, this file will be updated accordingly.

2KB

Anycubic_Vyper_Klipper_Printer_Config.zip

archive

Open

Anycubic Vyper printer.cfg File

• Download the Anycubic_Vyper_Klipper_Printer_Config.zip file from the link above;

  • Extract the printer.cfg from the .zip file;

• Log into your MainsailOS web interface;

  • Enter the IP Address of your Raspberry Pi you installed MainsailOS on from the previous section into a web browser;

MainsailOS

• Click on the Machine menu item;

  • Then click on the Upload File button;

Upload File

• Navigate to the folder that you extracted the printer.cfg file;

  • Click open to upload the file;

printer.cfg uploaded

• Click on the Update All Components button;

Update All Components

'Updating All Components' will update Klipper, Moonraker, Mainsail and System files. This process can take a few minutes, wait until all updates are completed.

Upon completion of the updates, the system will automatically restart and load the printer.cfg file. This is the first milestone, enjoy it, you should now be connected to your Anycubic Vyper 3D printer!